How To Clean Spectre Performance Air Filter

Asked by: Eimantas Gopfer

asked in category: General Last Updated: 1st June, 2020

Can I use K&N cleaner on Spectre filter?

you can use any kit like the K&N kit, most places the K&N kit is cheaper then the spectre kit is. then LIGHTLY oil it, dont soak it.

what can I use to clean my K&N air filter? Liberally spray K&N Air Filter Cleaner or K&N Power Kleent onto both sides of filter and allow to soak for 10 minutes to loosen the dirt. Do not allow cleaner to dry on air filter. Rinse off air filter with cool low-pressure water from the clean side out in order to flush the dirt out of the filter.

Also asked, can you clean a Spectre air filter?

Spectre air filters are similar to K&N air filters. They do not need to replaced; they can be cleaned, re-oiled then re-used. Spectre recommends properly cleaning your filter once every 7,000 miles for best results, but the specific interval depends on the type of climate in which you you live.

Is K&N better than Spectre?

The only difference between K&N and Spectre is the price. Same s*** different names. They are right about the paper filters, if not maintained properly clothe filters can kill your engine. Paper filters very well but does not flow well.

26 Related Question Answers Found

What oil do you use for air filters?

well, you could try thick motor oil, but you should use air filter oil , because it is sticky, and will catch the dirt and junk. wd40 might not work. and, if your lhs is closed, you could go to pepboys, or homedepo,etc. and get atv air filter oil.

What does a Spectre air filter do?

With its HPR (High Performance Replacement) synthetic air filter media, this air filter has been designed to provide more horsepower and quicker acceleration by allowing more air flow into your engine than ordinary paper filters.

Can I clean my air filter with soap and water?

Cleaning Cotton Air Filters Next, fill a bucket or wash tub with warm water and a mild soap and swish the filter gently around in it to clean out any remaining dirt and filter cleaner. Rinse and repeat. With the filter now free from dirt, it's time to let it dry.

Can I use wd40 on my K&N air filter?

Can I use wd40 to oil my k&n air cleaner. Wd40 has much more than just a lightweight oil in it. Diluted simple green and water is fine to clean it with just pull the filter off the bike first and make sure it is fully dry before oiling.

Can I clean my K&N air filter with soap and water?

Apply WD-40 degreaser generously on the filter. Alternately, use warm soap water. Scrub it, generally with your hand or a plastic bristle brush is alright. Wash it with plenty water - About 3 minutes of free flowing water under tap in opposite direction of functional air flow.

Can you clean a K&N air filter with simple green?

Simple Green is not harsh at all. I would rather you use the supplied kit, only since its for that type of filter. As long as you use the oil to re oil it, you should be more than fine. Re: Washed my K&N air filter with Simple Green.

Are K&N air filters worth the money?

Are K&N Air Filters Worth the Money? The stock air filter is almost never a restriction point. CRC Sensorklean will remove oil from the MAF. If you over-oil the filter, then yes, it'll mess up your MAF sensor and even clog up your throttle.